(a) the aluminium joinery used in the manufacture of the Product are finished in accordance with AAMA 2603-05 performance standard for exterior architectural aluminium joinery, and also in accordance with WANZ SFA 3503-03:2005 Aluminium and Aluminium Alloys - anodised coatings for architectural applications;
(b) the doors and windows of the Product comply with: NZS 4211:2008 Performance of Windows, and NZS 4223 Code of Practice for Glazing in Buildings; and
(c) As required under NZS 4211 the product or products specified will remain watertight.
If the Product does not perform as warranted, the manufacturer will make good the Product by, at its option, (i) replacing or repairing the affected Product, (ii) supplying equivalent Product, (iii) paying the cost of replacing the affected Product, or (iv) refunding the cost of the affected Product, subject to the following terms:
(a) that the window manufacturer is advised of and given an opportunity to inspect any fault;
(b) that any claims under this warranty need to be made in writing to the window manufacturer within 7 days of the fault first becoming apparent;
(c) that this warranty is not transferable and only applies to the original purchaser, unless the window manufacturer agrees otherwise in writing;
(d) that this warranty only applies:
(i) where the Product has been maintained in accordance with the maintenance procedure specified;
(ii) to a defect in the workmanship or a defect that is directly attributable to a defect in the material of the Product; and
(iii) where the purchaser has paid in full for the supply (and installation if applicable) of the window joinery;
(e) that the warranty does not apply to any:
(i) glass or glazing materials used in the joinery;
(ii) defects due to any cause beyond the manufacturer's control including, without limitation, defects in the structure to which the joinery has been affixed;
(iii) materials, hardware or componentry not manufactured by the window manufacturer;
(iv) weathertightness - where the contract is one of manufacture and supply only, the junction between joinery and cladding systems is the responsibility of the builder;
(f) that the window manufacturer will not be liable for any consequential, indirect or special damage or loss including, without limitation, any loss of profits;
(g) that the warranty does not apply to any fault caused by incorrect installation by anyone other than the window manufacturer or its authorised agents, and/or any installation otherwise than in accordance with the installation guide current at the time of supply.
This warranty is offered by the manufacturer of Foncci Aluminium Co., Ltd.
If you would like to know more about our warranty agreements, please contact us for further assistance.